TheKitchenix

how to install a pot filler water line

Start by accessing the nearest cold water supply line, usually under the kitchen sink or in a basement or crawlspace, and pick a tap point close to the pot filler location [6]. Install a T-fitting on the existing line, attach a shut-off valve to it, and secure it according to whether you use copper or PEX [4]. Measure and cut the new water line, run it from the valve to the mounting spot without kinks, and support it with pipe brackets at regular intervals [5]. Drill the mounting hole, then mount the pot filler, checking it is level and tightening hardware [7][3]. Thread the line through the hole and connect it to the inlet, using thread seal tape or compression fittings as your model requires [1].

Sources

Answered from the TheKitchenix knowledge base.

Ask your own question

Or GET /ask/o/your-question-as-words or /ask/o?q=your+question.